This is a replacement frame for Rayban Aviator lenses (in case your original frame has been damaged). Filament (1.75mm) is used as pin for the hinge. You can use hot water or a heat gun (with caution) if you cannot insert the lenses. The same way you can modify the curve of the temples if you are not satisfied with the fitting.
Print instructions
Category: Glasses Print Settings
Printer Brand: Prusa
Printer: Prusa Mk2
Supports: Yes
Notes:
For the best printing result it is advised to use PVA for support material. Otherwise, it is important to use the suggested settings below.
Cura Settings (for the frame)
Layer Hight : 0.1mm ( or 0.06mm)
Support : Yes
Support Density : 20%
Support Z Distance : 0.2mm
Support Horizontal Expansion : 0.5mm
Enable Support Interface : Yes
Support Interface Thickness : 0.4mm
Support Interface Density : 100%
Brim : 1mm (for the frame, if you have adhesion problems)
Post-Printing
Use a piece of filament (1.75mm) as a pin.
** Thank you for your interest in my designs. If you want to support me please consider a small donation at: paypal.me/stamos3d
Aviator Sunglasses
by Stamos · original on Printables ↗
Fashion / Other Fashion Accessories
♥ 151⬇ 1.5k🖨 2 prints
Print profiles
ra_temples.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
ra_frame.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print