In this project, we're 3d printing Link's Hylian Shield from Zelda.
Read the full guide on learn.adafruit.com
It’s over 450mm long and features a built-in handle. It prints in just 2 parts. The bottom part is printed upside down so the support material is easy to remove by hand.
You can download the design and customize the parts to fit your 3D printer.
Print instructions
Licence: Creative Commons - Attribution - Share Alike Category: Props
Link's Hylian Shield
by Adafruit · original on Printables ↗
Costumes & Accessories / Props
♥ 178⬇ 790🖨 6 prints
Print profiles
shield-tri.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
shield-bird.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
shield-btm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
shield-top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
linkshield-full.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print