Here is a Replica of the Medallion that Zeus gave to the Baby Hercules. Ready for your Possible Cartoon Prop or Cosplay project. with ribbon mounts on the rear that are a push fit no glue required.

I printed mine in Fillamentum Gold Happens so to get the awesome Gold Sparkle going.
and i used 25mm wide Red Satin Ribbon

I hope you enjoy.

Thanks

Bugman

If you like what I am doing please consider buying me a coffee or tipping. 😁👍

Buy me a coffee

Print instructions

Printer: CR-10

Rafts: No

Supports: Yes

Resolution: 0.2mm

Infill: 10%

Notes:

The Medallion and Ribon Inserts should be both painted flat on there backs with support to help with the bridging in the medallion.

Post-Printing

cut a short piece of 1.75mm Filament

and another

position about 5mm from the end of the Ribbon

fold the Ribbon over the Filament

insert the filament and ribbon into the recess

then push in the insert

you will need to bang it into position

and repeat

Hercules Medallion

by Bugman_140 · original on Printables ↗

Costumes & Accessories / Props

♥ 208⬇ 861🖨 8 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗cosplaydisneythingiversehercules

Print profiles

ribbon_insert_2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
ribbon_insert_1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
hercules_medaillion.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print