This Case fits a Raspberry Pi 3B and also fits a SenseHat Board and has a second cover for GPIO, Camera and Toggle access... Top vents mirror display grid.
Case is designed for Screw down and will accommodate the board without screws.
Modified io printing supports to snap out more easily...
Screws...
Pi takes M2.5 (a set of 4 screws and nuts needed... 4 standoffs and another set of 4 screws for Hat Boards) . The platform for the MLB is a snug fit, so it is possible to skip the screws).
Print instructions
Please NOTE! Remove the MicroSD Card before assembly and disassembly!
Print GCode for ABS and PETG contains supports for IO opening Bridges that will snap out... SenseHat Top cover has pop-outs for GPIO, Camera and Toggle.
Fits Bracket for Prusa I3 (for Raspberry Pi 4B case)
Please send a note if you like it or notice something that needs improvement.
Thanks for critical comments past and future...
Raspberry Pi 3B+ Case (SnapTop) fits SenseHat
by Carter · original on Printables ↗
Gadgets / Computers
♥ 103⬇ 1.4k🖨 23 prints
Print profiles
pi3b-case2-shtop.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
case4pi3-top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
case4pi3-base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print