Fits Raspberry Pi 4 B and Hat (SenseHat)
This Case also snaps to Domed Top from ...
"Raspberry Pi4B Case for Noctua 40mm x 10mm Fan"
Toggle and access for camera and GPIO and Toggle.
Screws...
Pi takes M2.5 (a set of 4 screws and nuts needed... 4 standoffs and another set of 4 screws for Hat Boards) . The platform for the MLB is a snug fit, so it is possible to skip the screws).
Print instructions
Please NOTE! Â Â Remove the MicroSD Card before assembly and disassembly!
Prints with supports for io, best to build with screws and supports for the Hat board (brass standoffs).
Added Blank top with Slot for IceCooler by request... It has not been checked for fit as I don't have an ICeCooler. Print at your own risk!
If you do print it and you can tell me how to fix it... I will.
Raspberry Pi 4B Case (SnapTop) fits SenseHat
by Carter · original on Printables ↗
Gadgets / Computers
♥ 397⬇ 3.1k🖨 28 prints
Print profiles
toggle5.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
gpio-cover-togglecamera-access.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pi4bsh-cover.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pi4bsh-base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print