Quality plugs with effective grip. You will never lose your plugs again and will protect your bar in case of a crash. With this specific design the plug is very strong and if you over-tighten it, you will not destroy the plug but only the wedge (in contrast with the usual wedge design). There are two sizes: one with large (32mm)outer diameter if you are using lock-on grips (the cap will also protect the rings) and one with small (28mm) outer diameter for simple grips. Except for the printed parts you will need a pair of M5 bolts (25mm).

Update 19 May 2022

The the expanding part (aka wedge) has been redesigned in two parts, so it can be printed easier. No supports needed for the plug. There is a sacrificial layer. Also anti-rotation tabs have been added. It is more durable and easier to install.

Bar-End Plugs

by Stamos · original on Printables ↗

Sports & Outdoor / Outdoor Sports

♥ 133⬇ 703🖨 9 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗plugbicyclebikebarendhandlebar

Print profiles

Plug 28mm v2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Plug 32mm v2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
cone.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
expand part 14mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print