Case for Raspberry Pi and Sense-Hat board
SenseHat NOT required!
Breakaway Supports included.
New .35mm smaller Z, led window, pop-outs for joystick and GPIO, camera slot and insert cover, io ports edited.
Snaps together Bracket for Case and Prusa I3 MK3 available.
need M2.5 screws to attach board to bottom case and Pi.
One place to Get a Sense Hat...
https://www.adafruit.com/product/2738
Print instructions
The case snaps together, breakaway inserts support openings... no other supports needed.
use a brim to hold down corners... when built with ABS
Case for Raspberry Pi 3b+ and SenseHat
by Carter · original on Printables ↗
Hobby & Makers / Electronics
♥ 230⬇ 2.3k🖨 16 prints
Print profiles
sensehat-case-toggle2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top-slots.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top-camera.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print