A flexible velociraptor! How cool! This is a very flexible (with 19 joints!), print-in-place model I spent a long time designing. A lot of attention to detail is in this model, and a few of the smaller tail links are weak due to their size so be careful! He can stand on his own or hang from something; he can even bite his own tail! He should print and pop off the board in a completely flexible state. He seems happiest when hanging from a computer monitor. Have fun!

Not suitable for small children, the tail end pieces may be fragile and could break off and be swallowed.

Check me out on Thingiverse: https://www.thingiverse.com/Cavedog/about

Check me out on MyMiniFactory: https://www.myminifactory.com/users/Cavedog

Print instructions

Make sure you print him on his RIGHT SIDE. His tail is tapered and I designed him so that his tail sits flat with the right side of his body for printability. No supports or rafts are needed. I used 210° first layer temp, 205° printing temp, 60° bed temp for best results. My printer is dialed in well; if you experience issues I suggest printing at least 125% scale, slow down a little and try slightly higher or lower temperatures.