You can glue a 10 x 1.5 mm round magnet in the base.

Recommended infill angle: 90°

Low speed and high temperature will create a shiny top surface.

There are "holes" inside the model to make some of the top layers more uniform, and they were created with 0.2 layer height in mind.

If your top surface is not flat & shiny and you see scarring, then make sure to check this guide: https://bit.ly/2UtN0I1

World of Warcraft Alliance Logo Magnet

Art & Design / 2D Plates & Logos

♥ 108⬇ 808🖨 10 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗ofkingworldwowwarcrafthordealliancelegionillidanlichdurotanundeadelvenhellscreamthrallsylvanasazerothorgrimarforsakenguldangrommashdeathwingfuriontyrandecrusadeburning

Print profiles

wow-alliance-logo.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print