A modern take on iconic Plague Doctor mask.
Print instructions
Fits snuggly into 250x210x210 build volume of Original Prusa i3 MK3 in one piece. Alternatively, you can print three separate pieces and glue them together.
Single piece needs supports, overhang angle 30°and support from build plate only is enough.
Separate pieces could benefit from brim.
Rescale as you wish.
You can use cheap shades for the goggles and cut them to fit.
Plague Doctor Mask
by Jindřich Beneš · original on Printables ↗
Costumes & Accessories / Masks
♥ 610⬇ 2.9k🖨 28 prints
Print profiles
plague_doctor_eyes.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
plague_doctor_chin.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
goggles.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
plague_doctor_whole.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
plague_doctor_beak.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
plague_doctor_single-piece.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print